Sign in Please read the rest of this article for everything else you need to know about your machine and its door lock issue. Once the temperature is reached, the lock opens automatically. Push the start/pause button to stop the current wash cycle. To do this youll need to access the underneath of the top panel where the lid lick is located. The drain hose is where the used water is pumped out of the washer. 4. If this occurs, see the manual or technical sheet for information on what the error code(s) signify. This will activate the diagnostic (self-test) mode on the washer. As washers get older, they develop the occasional problem. If the lid still does not lock, then you may have a problem with the lock mechanism, wiring, or the control panel. And remember to calibrate the washer after it has been installed in order to complete the repair. 3-Step Guide, How to Bypass Lid Lock on Whirlpool Washer? Other possible causes include a faulty Maytag washer door lock switch and a faulty main control, to name a couple. The most common Maytag washer lid lock error is a blinking light that indicates the lock mechanism is broken. & KITCHEN CLEANING, Refrigerator After removing the screws holding the back panel, remove the top control panel and disconnect the lid lock wiring from the controller. As previously said, it should be replaced. You can still reset the machine though by pressing a few buttons. Always clean the door area for soap build up. First, remove the back of the control panel by removing all of the screws on it (watch out for static electricity if there is carpet). /TM /* Lucia Maria Angela Field, Richard Dunn Death, Car Lots In Mississippi With No Credit Check, Playwright Wait For Page To Load, Flatley Foundation Board Members, Group Of Islands Crossword Clue,